Just tried powder coating for the first time tonight. I watched Elvis ammo on YouTube do a huge batch, he didnt pay too much attention on how he placed them. I'm sure a lot of you have seen this? I mean it wasn't absolutely perfect but the coating was 99% it look like on his vid. The problem is it was about a week ago when I watch that video and I forgot he lowers the temp to 275 deg. I had forgot about this temporarily until they were done, had some of them stick together, and they of course leave a bare spot when I break them apart. Thats why he lowers the temp.
Also about half of them did not cover very well on the outer bearing surface rings of the bullet. The most important part. I think that was the lack of powder, I should've been more powder when I was coating/ swirling them.
Using Eastwood Ford Blue, just figured I would get peoples opinion on a second coat before I try it. I did them at the 400 for 20 min and some came out really well almost perfect. Others not so much due too the non coverage or leaving a place from pulling apart.