So , with the NOE sizing system letting me size very incrementally and cheaply ( like for my .30 cals I have .309.310.311.312 .313 and .315 bushings)I've been ordering molds that are a good bit over sized . For instance my Mosin slugged .313 but the new mold o just got for it is .316 as cast. Figured it's better to go big from the git go and just keep sizing down till it works. Seems like a lot less of a hassle then trying all sorts of stuff to size up an undersized bullet.
Anyhow this leads me to a question I've been wondering while looking for a mold for my .270 win.
At what point do you say , hay this is just too much to size down ? Or does it matter if you can size it down in small incriminates at a time? Like would would something like a .284 down to .277-279 be too much of a stretch ?