I would appreciate you rifle shooters informed suggestions, for a plain based rifle bullet mold.
I am eyeballing the mp molds 311-410 hollow point mold.
In a perfect world it would be easy to cast, easy to load, clean shooting and accurate in multiple rifles with multiple powders, and compatible with powder coating.
*smiling*
I think this is doable.
I would be happy with a ten shot group that could be covered with a quarter.
I would be very happy with dime groups.
My H&Rshoots dime groups using PMC ball.
My range only goes to fifty yards.
I have 3, one quart freezer bags filled to bursting with hundreds of mixed
headstamp 308 Winchester brass,
that I have been loading and shooting for the browning;
Fired casings wet tumbled, full length sized/deprimed, trimmed/deburred/chamfered, tumbled again in pins, dried in an oven, then bagged.
Don't try to talk me out of this.
Except for better ideas. I am open to ideas.
I've got several pounds of IMR3031 and IMR4227. Small amount of varget, and some 4895.
The 170 flat nose lee bullet without gas checks gave ok results with the Browning BLR, 20x4227 and 30x3031 both shot well.
I have a hard time with the awful trigger, uncomfortable for me stocks, and poor sights on the browning.
I really like that specific browning rifle, it is not for sale.
That being said, my example is a terrible target rifle.
With the greatest sadness I must say that the H&R single shot rifle does not like the
lee bullets, the way I loaded the cartridges, at all.
(But I liked the H&R enough to buy it last month, I like how that rifle feels in my hands and shoulder)
(Heavy barrel with scope base, no iron sights)
(My mistake for picking the thing up haha!)
(I am considering replacing the 3-9x scope on the single shot rifle, with a sig sauer romeo 5 sight, the idea makes me happy...)
(maybe I will not like a electronic sight single shot 308 Win rifle, only one way to know I suppose)
Sent from my SM-G930T using Tapatalk