So question gents.
I'm hoping to start my hand at making bp...have been following the MASSIVE thread going for a while - all the while trying to catch up on older posts but it's thousands of posts long by now....it'll take me a while
I shoot mostly rifle but hope to get into pistol at some point. This means pressing powder.
I currently don't have a shop press....and if I got one it would be only for this use. Still may be worth it in the end but.....it got me thinking about alternative ways to apply the right amount of pressure to powder in a press die to get compression.
Is is possible to have a die made that would have a smaller diameter but longer length to use the compound force of a heavy bench vice instead? You'd end up with much smaller pucks and it would be very much more time consuming....but...doable? Is th juice worth the squeeze or should I just buy a press and find a place for it?
Sent from my moto g(7) power using Tapatalk