Thanks in advance for your opinions and suggestions.
1. LBT firelapping method. Where can I find detailed instructions, sources of required materials, etc.? Thinking ahead -- waaay ahead -- I once corresponded with Veral Smith, but have managed to lose the literature he sent me oh so many years ago.
2. In a Ruger Bisley Vaquero, .45 Colt, two cylinder throats measure .453 (perfect) but four measure .451 to .4515. I want to open these up. Since I also want to firelap the bbl, as an experiment to see if I can end up with a slightly choked or tapered bore, I thought about firelapping the four small cylinder throats simultaneously, as well. Is this a valid idea?
[The bore slugs at .451 with no restrictions that I can tell. ]
3. What would you recommend as a better alternative?
4. What do y'all think about Taylor Throating?
5. Where can I find molds for or finished lead, hollow base wad cutters in .451 or .452? I like the .32 or .38 Speer type, but they are not made in .45.
Thanks again.
No Plea