Hello all A few days ago I ordered a Lee 312-160-2r mold then I found this site and realize I should have gotten the 155 but will try to work with what I have from reading the stickys.I am new to bullet casting and would rather not do to much expierimenting.
If I understand right I can load 3006 1903 springfield plainbase with 13 grains of red dot without the gas check. do they need to be sized?
SKS and AK 5 grains of red dot Does that cycle fine?,assuming plain base ?
I also have a 308 enfield and a hk g3 308 are there any good recommended loads for this without gas checks?Do the bullets need to be sized?
If there was a more better powder load for all these say using 2400 I could do that I just use red dot for everything else I have.
What size and sizer do you recommend if I need one?
Thanks in advance for helping out a newbie.