Okay, tonight I tried my hand at Hi-Tek coating. Have been powder coating for sometime now but wanted to try Hi-Tek. The adventure didn't go well at all as I broke two cardinal rules. First was I applied a to thick of a coat. Second was I apparently didn't allow the coats to properly dry. Now I have about 200 rough and terrible looking casts. They pass the rub test and the smash test but I just don't want to shoot them in my gun.
Question...if I throw these back into the smelting pot will the coating burn off and float to the top the same as powder coating does? I really would rather recast these and do the Hi-Tek right than just shoot them.