I'm trying to find a consistent method for annealing cases. I'm finding it quite difficult right now trying the water pan and drill method. My engineering senses are telling me that any non-automated annealing method is horrific for neck tension.
Just trying to find a measurable way to diagnose annealing condition is shady at best. What would you guys describe the annealing job of this case? Too little, too much? Too far up the case? Too far down? My guess is that the annealed portion should go as far as the bullet but I'm probably more concerned about knowing proper color range (if that even means anything)...
I'm familiar with the article from 6mmBR but that assumes that I have an automated annealer.
shoe