nobade,
Yes he has. I would get a PB mould.
Gents,
I contacted Mike at TJ's barrel liners yesterday. I asked him if he could hammer a liner to 1/2 inch OD instead of the 9/16 that he offers (2 are 9/16 and the other is 1/2 OD)
of the things I listed;
Barrels that are available & might work ???
.32-20, bore is .305, groove is .312, twist is 16
.32-40, bore is .315, groove is .323, twist is 16
.32spec, bore is .315, groove is .321, twist is 14
I would really like the 14 twist................ if I did the math right, The greenhill formula works out to just over 15 for the 311407, , but I think I would like to try and lean toward something in the 200 grain area and then the 14 would be a closer fit.
If my math is right and the 14 twist can't be hammered down to 1/2 inch, what will I be giving up as far as bullets I could possibly use if I have to go with the 16 twist....or as I asked in my first post, Am I all wet ? (rich, don't answer that)
Thanks again