FINALLY got my lube in had awhile to use the old LAM11 again. stuck in a stick of hollow speed green, placed a lightly pre lubed cast .44 250 gr. SWC, lowered the handle and lightly rotated the top screw until i felt resistance, tightened some more, and raised the handle. LUBE EVERYWHERE. top of boolit to the bottom. did the sensible thing and read the instructions off the net. says to decrease the depth of seating by raising part L. i have raised part L until it is as high as it will go (against part K), raised the bar, part N as high as it will go and i still am getting lube all over the boolit. i have run 2 thru it w/out tightening the top screw until the boolits are coming out dry, then very lightly, barely tightening the top screw again (yes the boolit is already in the sizing die when i do this), and the lube still covers the boolit almost to the tip. i took out the die and it says .428 on the top of it. the top punch is part of the original set up but when i ordered the die and remember confirming it was for this die. been a long day and i am too tired and disgusted to continue this tonight. what am i doing wrong?? THANKS john