Mods-I'm not sure where to post this so please move to the appropriate spot.
I have a (ahem) few rounds of 7.62x45 surplus that are in sad, but not totally ruined state. I am trying to disassemble them but my Forsters puller won't work with them in the RCBS RC press as the round will not protrude far enough for the jaws to adequately grip the projectile. I am NOT going to pound these apart, so forget that. They have been sitting off to the side and I would like to get the job done but I'm at a sticking point. Does anyone have an idea of a quick takedown of Milsurp stuff. I'd even go as far as <gasp!> buying an especially prized tool for the job, that is, if its within my tight-wad budget.
Seriously though, any thoughts? Thanks!