Win 1895 (Miroku) Reassembly

[MikeF35]

I’ve searched all over the internet and cannot find a reassembly instructions/video for specifically a Miroku 1895. I am struggling to determine the correct way/best technique to reinstall the hammer spring + insert and hammer strut + strut collar. Predominantly the issue I see is how to compress the spring to get it all in there (without everything going flying, making my hands bleed more, etc.) The schematics below show the parts in question circled in red. Thanks guys!

IMG_0104.jpg

[pietro]

.

Here ya go: ( about minute 32)

https://www.youtube.com/watch?v=v3fgm3RJn0Q

.

.

[MikeF35]

Unfortunately not quite the same (no lower tang removal for one). His hammer spring/strut/etc. remained all together with the lower tang removal - wish that was my case. All of my parts are completely separated right now- see below pic.

IMG_0106 Medium.jpeg

[K43]

There is a small hole on the bottom end of #47.
#46, #45, and #48 need to be assembled onto #47, spring compressed, and a pin or small nail place in the hole in #47 to retain them with #66. Then place the hammer in the receiver and complete putting the spring/strut assembly in place.