I'm sure the answer to my basic question is buried in a thread somewhere but the search engine for the site doesn't return anything. I guess there's an issue with the site? So I apologize if this has been asked before.
Need advice on a 9mm Lee mold. I'm just getting into casting; been reloading for 6 years. My 9mm carbine shoots fine using Berry's 9mm 124 gr bullets with diameter of .356.
From reading Lyman's Cast Bullet Handbook and 51st Reloading manual, it's recommended to cast a bullet .001-.002 over groove diameter. Lee only offers 9mm molds with a .356 diameter. Here's my question, do you know if Lee 9mm molds cast oversize? If so, by how much?