Hi all,
I am going to start a 338 Federal bolt action project rifle. I have not started reloading yet, and this will be my first venture into reloading. It will be a while before the rifle is together, as I will be having a rifle re-barreled. I am thinking that, in the interim, I can start building my reloading station and forming brass, since 338 Federal seems to be going the way of the CA condor.
Looking for recommendations for a die set that any of you have found to work well to reform 7.62/308 brass.
If you have found extra steps, and additional equipment, that increase your success rate in forming good brass, I am all ears.
Any general suggestions would be helpful as well.
Thanks,
-AZ