I have a friend that ordered a 200gr mold. He was hoping to use it in his revolver. He hasn’t gotten it yet but when he showed me the mold he got from accurate it says nose too long for most 357 magnums. My question is can I trim 357 brass to 38 special length so I can crimp the brass in the crimp groove on the bullet? Is it worth trimming 357 brass? I have a ton of 38 special brass but I don’t know if it will hold up to those pressures. I know I saw a post a while back about using 38 brass for this purpose but I can’t find that thread again.