I might have posted this a few years ago but I wanted to post again. I have noticed that some of my 45LC and 357/38 shells will not always fit fully in the cylinder. It's not the boolite
as it seems past that is when I have to use force to push it in.
Sometimes they work they don't if they do work then it takes work to remove from the cylinder. Other no problems loaded fine and shot fine just every few rounds I find one that just will not fit.
Is it the dies? Am I not going down far enough when I do the full-size die? I'm I not belling enough or too much?
I have a $270 gift card to Brownells no choice my old boss was a big fan of paying too much. I'm trying to come up with ideas to spend the money on. There is not much else I want and even with free money it's hard to look at items and say "I can get that for $20 cheaper here or there." Thanks.