Something new, I shot my 1930s vintage bubba rebuild ‘03 at a 2 gun yesterday and had 3 rds fail to go bang. Normally it’s 100%. Shot about 70 rifle rds. I’m just curious if I didn’t have the bolt all the way down and if having the bolt not all the way down could have caused the misfires. They were all handloads that chambered ok but a few felt tighter than the others. All were run through a case trimmer prior to loading. The primer hits looked about the same as the others. I had checked them all in a 30-06 check gauge and cycled them through the gun [safety engaged] after they were reloaded last week. Only missed 2 with the rifle. Brain faded with my 625 and skipped over 2 targets and reengaged 2 others after a reload. Duh. No surprise I came in last, fyi boltguns and 6 shot 45acp revolvers cant keep up with hi cap pistols and ARs. Shot with a good squad of guys that worked with an old man. Had a fine time. Thinking next month I’ll try out my Thompson as I’ve never shot it in a match.