Hello All…
I have a Winchester model 69, that I am restoring, and intend to make it an active shooter. It is a “true” model 69…. Not 69A , nor 697 etc… it has the original firing pin cap, with the rotary fire/ safe knurled knob selector.
I am currently working on the scope. It had a modern style aluminum, two piece, Weaver base, and a modern Simmons 4x9. I would like to change this stuff out to a more period type setup, and I found a steel Weaver base, with the rings that bolt down, into it. I’m trying to instal those, then find an old K-series scope.
My problem is that the base is more than obviously, not the correct base. Before I post pics, of the mismatch… 1) I verified this IS model 69 ( see above pic, and bolt cap fire/safe description ) 2) I’ve cross checked thru several different sources , that Wever 2121 base IS for Win model 69. 3) the base in the original package ( marked 2121 ) is actually stamped with Weaver & 2121.
On the receiver, the forward mounting holes are spaced closer together , on center, than the rear holes are. These are the aluminum bases, resting in place, just for clarification.
The over all length of the base is way too long. The rear base/ receiver face is not machined to correct profile.. it seems to be a shallower, narrower curved surface, designed to possibly meet a barrel, as opposed to the larger radius of the receiver. There are only three holes in the base, as opposed to the four in the receiver, and in this end of the base ( that I think is not machined correctly ) are two of the holes, and they are spaced the same , as the rear two holes in receiver.
If I hold the base to receiver, so that the two holes of base, and receiver, line up, the base flies out over the chamber part of receiver and the foot ends up hovering over the actual barrel, as the crossbar part of base makes contact with receiver.
Obviously something is wrong with the combination, but I’ve verified … at least by manufacturers specs, that I do have the “correct” pieces . I do not believe that Weaver would sell a base, for an application, that to install, the owner must re-machine a contact surface, and section out and weld the crossbar, nor drill and tap barrel.
Any ideas where cross referencing has gone awry, or any advice on “ they used this for that, until this model was made”….. ?