https://castboolits.gunloads.com/sho...use-of-fillers
Post #2 will give you a good description of the proper use of the dacron filler. Here is the basic information;
The “dacron” is polyester fill as commonly found in pillows and toys. It also comes in sheets called “batting”. It can be obtained very reasonably at most any fabric store.
The dacron batting comes in various thicknesses. I prefer that which is about 5/8" thick. My wife recently bought me 10 yards which will give many, many thousands of cast bullet loads. With this current batch of batting I cut it initially across the width into strips about 3/4" wide. I then "eyeball" cut 1/2" wide chunks which is close to 3/4 gr.
A smaller chunk is cut for 1/2 gr and larger for a larger amount. I've cut some chunks that weight 1/2, 3/4, 1, 1 1/4 and 1 1/2 grs and have them in a "snack" baggie stuck on a poster board above my loading bench for quick reference when I need to cut new chunks. The batting will run thin and thick throughout the sheet so I again just "eyeball it" based on the thickness of the batting when cutting the chunks.
Pretty extensive tests have demonstrated that the weight of the filler does not have to be exact, only close. What is important is that there is enough so that it “fills" the space between powder and bullet. A little too much hurts nothing but too little poses problems. That's why I have the different size "chunks" so I can use the right size for the case capacity I am filling. For example; with most medium burning powders (3031, 4895, 4064) in and '06 to function an M1 a 3/4 gr dacron filler is about right. With slower powders that give a higher loading density like 4831 a 1/2 gr filler is about right.
I use a section of .22 cal cleaning rod in cartridges of .30 - .375 cal to push the Dacron chunk inside the case just so it is all in. The 6 to 10" section gives plenty to hold onto and sufficient "feel". Merely hold the chunk of dacron over the case mouth and shove it in with the rod. Sometimes it takes a couple three pokes to ensure all is inside the case mouth. I poke the chunks in until all the dacron is at the bottom of the neck or at least all in the case. It doesn’t matter exactly where just so long as y
ou don’t tamp it down on the powder as a wad and leaved a space between the base of the bullet and the dacron.
What you want to do is push it in to let the base of the bullet finish pushing it down and adding any compression against the powder. Thus, I do not push it down on the powder but let the bullet do that when the bullet is seated. Using the right size chunk of dacron this method then provides a "filler" in the air space between the powder and base of the bullet as the dacron will "fluff" back up to fill the air space.
Just don't tamp it down on the powder making it a wad.