Decided to start casting my summer supply of 45 bullets yesterday. Got my Lee 6 cavity cleaned and lubed and fired up my Lee 20# pot at 5.5 Started casting and had problems with the spout on the pot freezing every two or three bullets. After checking my notes realized that my memory of what setting to use was wrong, always had used just over 6. Also noticed that cut sprues looked odd, round on the bottom. Looking things over realized that the mold had a troughed steel sprue plate. Didn't notice this when lubing the mold and honestly can't recall buying or installing it. I guess the mind is the first thing to go, although my wife said it was something else but I can't remember what it was.