Pretty sure I know the answer, but I want to make sure the best way to crimp these gas checks. Bullet is RCBS 32-170-FN, cast of ACWW +2% tin, lubed with liquid alox. Bullets are coming out right on .324". Gator gas checks. Lee .323 push through sizer. Sized bullets come out .323". Bullet on the right was pushed through nose first and ended up with a skirt of copper/ sharp edge around the circumference, and it doesn't look square to the bullet. On the left was run through base first, appears nearly square with a slightly rounded bottom. I'm assuming the one on the right is not acceptable. Is the one on the left ok?