Gents,
I just picked up a Star Lubsizer and am getting ready to give it a go. I've used RCBS Lubesizers for years and have always been irritated by the lube that gets under the base of the bullet. Hoping the Star will address that.
Since I've had RCBS units all my existing lube is the "hollow tube" type. Can these be just dropped in the Star and the compression will squeeze the air out or will there be bubbles/voids on my bullets?
I'm hoping to be able to just use them as is but am afraid that this air pocket will screw with my ability to provide a consistent pressure in the resivour. Sounds like the Star can take a little work to figure out initially and not looking for another complication!
If it's an issue at all I'll probably just make an aluminum V funnel and use a heat gun to melt the hollow lube stick into the reservoir. I'm using LBT soft blue.
Thanks for any guidance!
Wade