This is how many I got with my brand new Lee two cavity .600 round ball mold before the mold was galled and unusable. I'm not entirely new to casting, it was properly cleaned and lubed. And to top it off, the balls were .004" undersized and out of round. I had to pound on it to get the balls to drop. I spent an hour drilling, tapping and lapping (leementing) and had to order some .002" shim washers to lift the sprue plate up off the mold so it doesn't gall on the entire surface of the plate and now it at least doesn't gall. What junk! Never again on the Lee molds.