Hey guys, first post in 5 years. I've been busy. Anyhow I'm trying to PC some NOE 311-247 in Columbia coatings super mirror black, 2 coats. I sized them through a Lee 309 die. That's where the problems began. First bullet stuck fast. I had to carefully drill it to give it room to swage in on itself. I then used a cotton swab with some RCBS case lube and lightly lubed the die. Got 80 bullets through with a few re-lubes. The handle effort on my Lyman t-mag turret press was substantial. When I pulled the collection box off the top of the press I noticed I had cause the bases to flow around the ram a bit causing 1-2 mm of flash in some cases. The powder coat stayed on. I then ran 2 uncoated bullets through and had similar results. Am I substantially over sizing? Its my first go with the lee sizer.