I'm looking for a specific bullet mould for 100 grain, 0.356" bullets. The profile is like Lee's 356-102-1R bullet, except it has a flat point.
It's not so much that I want to buy this mould, as that I want to put a name to it. There's a story...
I bought a bunch of these bullets from a gun show vendor a number of years ago. They are round nosed enough that they don't "play well" with my Taurus TCP's chamber, or more specifically with the short leade in the TCP's barrel.
The TCP is happy with any jacketed or plated bullet, and I would assume it'd do OK with a cast bullet that had a "step" at the bottom of the ogive. But this particular bullet, which I have too many of to just junk, is a problem.
Any direction would be very much appreciated.