Ok. So I bought 2 lee molds. I know not a great start, but I had to start somewhere. In any case I got a 124g .356 9mm mold, and a .358 38/357 mold. the 9mm seem to be fine. the 38/357 mold seems to be dropping out of round after the first batch. I cast a 2nd test batch today and found a little bit of junk between the plates. I cleaned it up and its still slightly out or round. the mold is supposed to be .358. after casting I am getting .357 to .361. after sizing there are a few spots that are not getting sized, and I am measuring .357 to .359. on a side note I am sizing at .359 for my cylinder throat size. Other than cleaning I am not sure how to deal with this...