As I said in my other posts, I am new to coating. I have a 147 grain HP mold coming with no lube groves. I believe the official cast size is listed as .359" I will see what it throws tonight when it gets here. I will be coating these as soon as the Eastwood powder gets here, and I figure out where to sent my toaster oven accurately for 400 degrees. Once I get all of that done, I will be sizing the coated bullets down to .358" for use in my various revolvers. My question here is will I have any issues running the coated bullets through a .356" sizer to use the same mold for 9mm guns? And if that is feasible, do I run them straight through the .356" Lee sizing die? Or should I run them through the .358" die first, and then the .356" die? What have you guys done in the past? And how well did it work?
-Mb