How do you guys restore/refurbish your primer post/rod..?? I'm having a hard time getting the primer cup rod to separate from the main body stem. I understand the rod is a press fit and loctite is used. But, after I burn the loctite, I'm still having a hard time getting the primer cup rod to separate from the main body stem. I've tried heating the stem. Then, put it in the freezer to shrink the primer cup rod. Still no go either way. Thinking out loud here, I'm gonna need to build a jig to separate the two. I can build a jig but was hoping you guys had a better solution. I'm open to suggestions.