I'm not 100% certain that this is the right place for this, but...
My fingers are a bit sore today. I sized all of my 30-30 cases. Then I hand trimmed them (no machine, just a hand tool). Next I deburred 100 of them and used my RCBS universal hand primer to install the primers. Tomorrow night (or sometime this weekend) I plan on loading them. Wish me luck because this is my first solo batch of cartridges using my own equipment. I'm trying to decide on a starting powder charge right now. It might take me a couple of days but I think I'm going to end up settling on 28.3 gn of powder. It's a little towards the high end of the middle of the minimum and maximum. IMR 4895 w/ Sierra 150 gn round nose bullets.