OK some great ideas from you guys. But the nozzle is clogged also. When I,m casting I have been using a paper clip to
unclog the nozzle from time to time. I tried using a propane torch to heat it up & the paper clip. No go it maybe clogged
in the top where the hole intersects at a angle with the bottom hole. The paper clip is .039 dia. I ran a .040 number drill
up from the bottom & I think it is ok now with that hole. I don,t know if I have room in the pot to get in the top hole at
the angle have not tried that yet.If any of you have a trick to getting to it I would love to hear your advice. I have a new
pot coming tomorrow. I still would like to get this working. If I can,t get the spout unplugged I will just use it as is & use
a dipper.
Fly