I just finished loading up the last boolits from my last casting session. I had to stop and dig wax out of the seating die three times in the last 120 bullets to keep it from seating the boolits deeper than the crimp groove.
When next I set up to cast, I'll be following it with a PC session. I'll be retiring all my pan lube stuff in favor of PC.
But . . .
Before I start loading any of those new PC boolits, or even sizing them through the Lee Bullet Sizing dies, I need to clean any accumulated excess lube out of them. So, what solvents are good at cleaning beeswax/parafin based lubes out of dies?
Thanks in advance.