So I'm planning to use the JGY370 motor, but after installing it to the main body it's obvious that the shaft is way shorter and doesn't have the "T" needed to spin the collator plate. How have others with this motor gotten it to work? I saw a post on someone welding some tabs on to the motor shaft, but would like to avoid that if possible.
I was looking to maybe get a shaft coupler like these.
https://www.ebay.com/itm/Shaft-Coupl...l/401366074041
Then maybe drill through for a short piece of brass on one end to create the "T". It may require enlarging the diameter of hole in the collator and main body, but no big deal and looks like the scad file can be updated to do that on the collator.