I recently got back into casting boolits for my 44 mag. I have pat's check maker and the Free check's The free checks works good but is hard on my hands. I like Pat's but it keeps jamming up when you try to pull the disk cutter back down in the die. I've gone through a few set screws that hold it in the holder. Im using coil and foil aluminum material. Seems like its building up aluminum material from cutting in the die wall making it a real tight fit. I clean it and it works for about 5-10 disks and starts to jam up again. I tried turning the die to find the sweet spot and it works for a few and jams up again. It jams after the disk is cut and you are trying to lower the cutter so you can slide the material to cut the next disk. I like the check maker but it is a real pain to use. It makes really nice gas checks. Any one having this problem using the same check maker?