Lead weight per gallon?

[Sean357]

Sorry if this has been talked about before, in fact it probably has but search function in Tapatalk is not great. A guy near me has some 45 cal boolits for sale, says it's about 1/3 of a 5 gal bucket. So 1.6 gallons of what look to be 185 to 200 grain boolits. Wondering if anyone has info on what lead weighs per gallon or cubic inch. Interwebs is giving alot of conflicting info on this. Just want to make sure I give him a fair offer, and at the same time not pay too much. Thanks.

Sent from my XT1030 using Tapatalk

[NoAngel]

This website says 151 pounds
http://www.aqua-calc.com/calculate/volume-to-weight


Consider it to be less for the air space. How much air space though is incalculable. So guess.

[Sean357]

Yeah that was the first one I came across, said 100 lbs per .88 gals. Just seemed really high, but I don't have a whole lot of experience at this point so maybe it's right.

Sent from my XT1030 using Tapatalk

[NoAngel]

I went on a casting bing a while back and filled a kitty litter bucket with 124g 9mm's. [Well, almost. call it 80%] There was no moving it. Not for this ole boy. LOL!

[Sean357]

Ok so I think that aqua-calc site is right. After figuring grains per lb and guesstimating from my 38 cal boolits it turn out that 150 lbs sounds right. Would come out at a bit over 5000 boolits. Wouldn't need to buy any light 45 cal boolits for quite awhile!

Sent from my XT1030 using Tapatalk

[funnyjim014]

Don't forget to figure in the air space. It's not a solid 1.6 gal

[Regulator.]

I tried to pour it in a gal milk jug to weigh jug melted oopps

[Hick]

151 would be the weight if there was no air space (the specific gravity of lead is about 19 times more than water, and water weights 8-something pounds per gallon-- 19 times 8 is 152). with or without air space its heavy!

[Sean357]

True I hadn't considered the airspace, should bring it down a bit. The guy is going to try and get a actual weight tomorrow and then let me know. At the least it's a few thousand given that 500 200 gr RN weigh about 14 lbs.

Sent from my XT1030 using Tapatalk

[OS OK]

I'll take a swag...80#.

[runfiverun]

water is 8.33 lbs per gallon if it's clean.
lead is about 730 lbs per cubic foot.
if you can eyeball about a cubic foot a [a little bigger than a gallon of milk jug] then reduce and subtract for the gaps you can Mark-1 eyeball it fairly close.

[NavyVet1959]

Simple math calculation, you just need a few conversion factors...

231 cu-in per gallon
708 lbs per cu-ft of lead
12*12*12 = 1728 cu-in per cu-ft

So, a cu-in of lead weighs 708 / 1728 = 0.40972 lbs

And a gallon of lead weighs 0.40972 * 231 = 94.64583 lbs

Now, according to wiki, solid lead has a density of 11.34 g per cu-cm.

Since there are 2.54 cm per inch, that means that there are 11.34 * 2.54*2.54*2.54 * 231 = 42926.5696 g per gallon.

There are 0.45359237 kg per pound (exactly).
There are 1000 g per kg.

So, 42926.5696 / 1000 / 0.45359237 = 94.636644 lbs per gallon.

And, depending upon the lead alloy, it might be slightly lighter.

Since there will be air space between the bullets, it's going to be less. Probably a safe bet that it will be more than half of the value of a solid chunk of lead, but there's too many variables to provide a completely accurate estimate. Best solution is to take a bathroom scale with you and weigh them.

Since you're talking about 1.6 gallons, take the above and multiply by 1.6

[OS OK]

I'm going to send you my checkbook Navy....needs some rithmetec done.

[762 shooter]

If you have some 300 gr 45 cast boolits, count out 2 or 300 into a container, weigh them, add water to top of boolits weigh the total. Now subtract the boolit only weight from the total and you have the water weight that filled up the air spaces. Convert to volume and subtract that volume as lead weight. Voila, the weight of air space as a ratio to the number of boolits you used.

762

[NavyVet1959]

If you have some 300 gr 45 cast boolits, count out 2 or 300 into a container, weigh them, add water to top of boolits weigh the total. Now subtract the boolit only weight from the total and you have the water weight that filled up the air spaces. Convert to volume and subtract that volume as lead weight. Voila, the weight of air space as a ratio to the number of boolits you used.

If you have a scale to weigh that, you might as well just weigh the bullets initially.

Besides, that "1/3rd of a 5g bucket" is probably not that accurate anyway. That's probably somewhere between 1/4 and 1/2.

[762 shooter]

If you have a scale to weigh that, you might as well just weigh the bullets initially.

Besides, that "1/3rd of a 5g bucket" is probably not that accurate anyway. That's probably somewhere between 1/4 and 1/2.

You are just weighing 200 boolits to get a ratio of air space to boolits. 6 pounds?

762

[runfiverun]

holy cow I'd just call it 40% air.
eyeball the volume and figure 60%.
by the time I got done with the math I'd have a headache and replacing my pencil lead wouldn't cover the extra dollar I'd lose.

[NavyVet1959]

You are just weighing 200 boolits to get a ratio of air space to boolits. 6 pounds?

6 pounds is too heavy for most of our powder scales and too light to get an accurate measurement with most bathroom scales.

[Ickisrulz]

water is 8.33 lbs per gallon if it's clean.
lead is about 730 lbs per cubic foot.
if you can eyeball about a cubic foot a [a little bigger than a gallon of milk jug] then reduce and subtract for the gaps you can Mark-1 eyeball it fairly close.

Actually a cubic foot is much larger than a gallon of milk. A cubic foot holds about 7.5 gallons of milk.

[gwpercle]

Math isn't going to give you the real answer.....just count them.