Snyders JerkyInline FabricationTitan ReloadingReloading Everything
MidSouth Shooters SupplyRotoMetals2Lee PrecisionLoad Data
Wideners Repackbox
Results 1 to 13 of 13

Thread: New Member

  1. #1
    Boolit Buddy
    Join Date
    Jul 2008
    Location
    MN
    Posts
    125

    New Member

    Hello,

    I just discovered this cast bullet forum. I started casting bullets in 1970 and am still using the same Lyman 61 lead melter with some minor repairs over the years and Lyman 450 sizer I bought back then. I am a retired cable splicer and worked with lead splice cases and lead cable for years so never had a problem scrounging casting lead. I have my lead pot set up in the garage with a swing away blower above it vented outside through a 4 inch dryer vent. Ron

  2. #2
    Boolit Master uncle joe's Avatar
    Join Date
    Mar 2008
    Location
    MS
    Posts
    501

    Thumbs up welcome RON

    Welcome Ron this is a great place to swap info on just about anything you can think of. I have not seen another forum that has as great a bunch of guys on it than this one
    Welcome aboard
    JE
    Μολὼν λαβέ

  3. #3
    Boolit Master


    Rick N Bama's Avatar
    Join Date
    Apr 2005
    Location
    In the Heart of N Alabama smack dab along Tornado Alley.
    Posts
    1,132
    Welcome to the board Ron. I'm a retired Service Tech (Installer/Repairman) from the local phone co. but didn't take up casting until a couple years after retirement. Unlike you, I did not take advantage of the lead supply I had close at hand while I was working with the stuff.

    Rick
    Democracy is two wolves and a
    lamb voting on what to have for lunch. Liberty is a well-armed lamb contesting
    the vote. - Benjamin Franklin

  4. #4
    Boolit Buddy
    Join Date
    Jan 2008
    Location
    Texas
    Posts
    109
    Hello Ron,

    There's a rule here that when new members post for the first time and mention anything about having lead or their source of lead, they have to send 50 pounds, in ingot form, to each of the first ten respondents to your initial post.

    It's a little known rule--so little known in fact that I'm not even sure the Search function could find it.

    So while you're packaging up the ingots to us in the flat-rate boxes, I'll see if I can scrounge it up.



    Welcome. Great, great bunch of folks here.

    Jeff
    If every single gun owner belonged to the NRA as well as their respective state rifle/gun association, we wouldn't be in the mess we're in today.

    So to those of you who are members of neither, thanks for nothing.

  5. #5
    Boolit Master copdills's Avatar
    Join Date
    Jul 2007
    Location
    South Carolina
    Posts
    825
    Welcome to the forum Ron glad your here just jump right in both feet lol

  6. #6
    Boolit Buddy RustyFN's Avatar
    Join Date
    Mar 2008
    Posts
    103
    Welcome Ron. I'm new to casting myself and this has been a great site for me. I think you will enjoy it here.
    Rusty

  7. #7
    Boolit Master Lead melter's Avatar
    Join Date
    Sep 2007
    Location
    Statesville, North Carolina...too close to Charlotte
    Posts
    516
    Quote Originally Posted by TexasJeff View Post
    Hello Ron,

    There's a rule here that when new members post for the first time and mention anything about having lead or their source of lead, they have to send 50 pounds, in ingot form, to each of the first ten respondents to your initial post.

    It's a little known rule--so little known in fact that I'm not even sure the Search function could find it.
    Cast Boolit Rules of Posting

    Section 12-7.012

    Subsection A-98

    Paragraph "C"

    Phrase "f"

    Clause 954-327

    This ruling applies to all/and any members gullible enough to fall for it.

    And in the event there are not ten posters within 10 days, the entire amount is then forwarded to the member who reminded the board of the rule [TexasJeff], and the member who relayed the information of the ruling's location [Lead melter].

    No need for any embarrassment, this stuff happens all the time.

    So, when do we get our ingots?
    "Ignorance is the parent of fear."-Herman Melville

  8. #8
    Boolit Master

    Join Date
    Apr 2008
    Posts
    4,947
    Heh, heh, heh, heh.
    Hey Newbie, remember, the only foolish question is the one not asked and acted upon.
    You gonna meet some great folks here. I wish they were on some of the other forums I am on.

  9. #9
    Boolit Buddy RustyFN's Avatar
    Join Date
    Mar 2008
    Posts
    103
    If I post two times in the first ten does that mean I get two shares of lead?
    Rusty

  10. #10
    Boolit Buddy
    Join Date
    Jul 2008
    Location
    MN
    Posts
    125

    New Guy

    I am surely being attacked by rabid lead scroungers. But I must be suffering from the effects of long term handling and breathing of lead fumes because I have CRS and won't remember the attack later anyway. Thanks for the warm welcome, Ron

  11. #11
    Boolit Master wills's Avatar
    Join Date
    Mar 2005
    Location
    La Grange,Texas
    Posts
    2,127
    Welcome to the asylum, and don’t believe everything you read here about sheep.
    Have mercy.
    A haw, haw, haw, haw, a haw.
    A haw, haw, haw

  12. #12
    Boolit Master uncle joe's Avatar
    Join Date
    Mar 2008
    Location
    MS
    Posts
    501
    Quote Originally Posted by ronbo View Post
    I am surely being attacked by rabid lead scroungers. But I must be suffering from the effects of long term handling and breathing of lead fumes because I have CRS and won't remember the attack later anyway. Thanks for the warm welcome, Ron
    yep he's gonna fit right in here
    Μολὼν λαβέ

  13. #13
    Banned

    Blammer's Avatar
    Join Date
    Feb 2007
    Location
    Asheville, NC
    Posts
    10,427
    welcome!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check