I am slowly getting my setup together, and am now in the mold searching phase. I am looking to cast for a Glock 9mm and a .40, and really need some advice on getting it right the 1st time. Molds are kind of expensive right now, not to mention are hard to come by if you are looking for one priced reasonably, so I want to make sure that I only buy it once if possible. If you were starting out, where would you begin in looking for the needed molds and such for them? I've heard that it is ok to shoot lead out of Glocks, and have heard that it makes them go Boom. As I don't have any experience either way, I am going to toss it out to you guys for your wisdom and advice. I'm always impressed with the level of knowledge around here, and that usually people are very helpful and non-condescending when answering questions of us Noobs. Thanks for anything you can share with me on this, it is greatly appreciated.