Ok, let me explain my situation, I am getting lead smearing inside the chambers, just forward of where the case ends(44mag cases), up into the cone shaped area just before the throat, and lastly in the cylinder throats. However my barrel is clean as a pin. Is there something that I'm missing?
I am using wheel weights as my alloy. I am water dropping them to harden.
Unique is the powder I'm using. I've tried several different loads, no luck, still leads.
I have a new mold from Tom, the 43-250K @.432"
I am sizing to cylinder throats which are .432"
New Ruger Superblackhawk
Anybody offer me some advice that might help, I 've thought about this so much my brain hurts!
Bones