Calling all .410 bore users

[comershooter]

I was told by lee after several back and forth e-mails about peoples pure enjoyment of the .410 shotgun and I was able to get them to agree to let me show support and they may produce them again they promised no guarantee but a chance at them making a conversion kit for there lee load-all to .410 bore so everyone express you opinion on this on I am hoping for lots of posts to this thread to show support for cheaply reloaded .410 bore shotgun shell.

[hoosierlogger]

Already have a Mec 600 JR that I use. Good luck though.

[Marvin S]

I may go for a complete one in .410 but for sure one in 28ga.

[autofix4u]

Id buy one...... or 3.

[shotman]

not to bad mouth the lee
BUT the 410 is one that you dont usually load the same load all the time. the lee is a little hard to change easy
I would go with a MEC and adjustable bar. 600 is good for slow easy loading the grabber is little faster and still easy to use . 650 dont size so it could be problem for used hulls

[woodyubet]

I'd buy one in 2 1/2 and one in 3 inch. I communicated with them in December of last year and they told me they didn't see enough profit in .410.

With all the machinest around you would think a simple hand loader like the Lee classic would show up....I think it would sell quite a few.

[jmorris]

Never cared too much for the Load all types, I have an old RCBS cast aluminum version. As for .410 I have a 366 that is the cats pajamas but I don‘t use it any more. The only .410 use I have any more is for snakes and it’s just not worth it to make a run every decade.

[comershooter]

Thread closed they have no interest now as they have to many projects from a call by john lee