Any suggestions on who could be relied upon to make a rifle barrel with 0.390" groove diameter?
Please send a message if you know someone.
Any suggestions on who could be relied upon to make a rifle barrel with 0.390" groove diameter?
Please send a message if you know someone.
http://www.bartleinbarrels.com ...... felix
felix
That would be an odd size. there will be none of the button rifle barrels in that size. To do a cut rifle barrel in that size would require a cutter box to be made for that size bore, approximately .010" smaller than the groove diameter. This could be very expensive for a one off barrel. There are several shops that do custom barrels but they all use standard bore sizes, including me.
Just curious, what cartridge would this barrel be used for?
It's a 9.5 x 52 case made from a Mauser A base brass.
I think that you could use .375 barrel.. In millimeters the .375 bullet is 9.525..
S
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |