I've been impressed recently with Accurate. But I really like some powders from Hodgdon, Alliant and Winchester...
Hodgdon
Accurate
Alliant
IMR
Vihta Vuori
Winchester
Norma
Other
I've been impressed recently with Accurate. But I really like some powders from Hodgdon, Alliant and Winchester...
WWG1WGA
First, define best.
Second, define application.
And then wait for everyone’s opinion. There is no one best powder manufacturer. There is no one best powder. I have jugs from all the manufacturers. And they each work for the given application.
For competitive long range shooting I don't purchase smaller the 8 pound jugs to minimize lot to lot load development. Powders like Varget are purchase 32 pounds at a time requested to be all the same lot. Normally with matching velocities accuracy is the same but it may take a little more or a let less to get the same velocity. On your list Norma is the only one that I have limited experience with. For most applications in handgun, shotgun and non-competitive shooting smokeless powder variables are not detectable.
2nd Amendment of the U.S. Constitution. - "A well regulated Militia, being necessary to the security of a free State, the right of the people to keep and bear Arms, shall not be infringed."
"Before you argue with someone, ask yourself, is that person even mentally mature enough to grasp the concept of different perspectives? Because if not, there’s absolutely no point."
– Amber Veal
"The Highest form of ignorance is when your reject something you don't know anything about".
- Wayne Dyer
It us an interesting question because several of the powder companies listed don't actually make powder. E.g. Hodgdon, Winchester, Accurate, Etc. And others source powder from a variety of manufacturers abroad.
General Dynamics in St. Marks, Fl makes powder for a few on the list.
That being said, a scan of my load journal shows that I've used more Alliant powders than any other.
Best will be completely subjective.
My needs are simple, i am not an accurate enough shooter to notice small differences.
I hope to get better.
I run a progressive so easy metering is important to me.
Also I believe in using powders with over 50% fill rate for safety reasons.
Hard to double charge if powder is flowing out of the case and I cannot seat a bullet.
Also easier to see charges and make sure the case is charged.
Cost is a factor, as is availability, so while I know of some that love the Vihta Vuori powders I have never tried any.
Also I am more interested in shooting than testing a bunch of powders so now that I can get powders easily I have standardized on just a few powders that meet my needs, HP38 for most pistol and TAC for 5.56 cover all that I reload now.
I am stocked up on those and just trying to use up all the other powders I picked up during the shortage.
This is kind of like asking which automotive company makes the best vehicles.
like mj said "Best will be completely subjective."
The best powder is the one I have loads worked up for. I have a big jug of a new-to-me pistol powder, due to cost/availability at the time of purchase. I have created only a couple of loads for it as of yet. But after my current powders run out and I am forced to learn how to use this stuff, I predict it will be my next and potentially last favorite... simply because I have enough to potentially last that long.
I have consolidated my powders to four. I only reload for revolvers and pistols. I use bullseye, unique, 2400, and h110. They all serve a different purpose.
Due to the price of primers, warning shots will no longer be given!
Honestly they are all good. Like mentioned earlier there are only a few manufacturers. They are then sold in bulk to be labeled by the brand name. I have found the equivalents powders to be very close and only require a minor tweak to bring in normal accuracy. As long as you match the powder to the purpose you wont have any troubles.
Sent from my SM-G950U using Tapatalk
"Speak softly and carry a big stick; you will go far."
~Theodore Roosevelt~
Agree, they all work. If there is a run on powder, Alliant will disappear first and be the hardest to get.
I've used IMR, Hodgdon, Hercules(Alliant), Winchester, Accurate, Norma, and V-V and they are all good!
Sent from my SAMSUNG-SM-G930A using Tapatalk
It is hard to say because of how it was before 2017 , if you did not have in stock enough of what you use normal ,you find what is about the same or close to it and go from there.,with different make of powder.
Life Member of NRA,NTA,DAV ,ITA. Also member of FTA,CBA
I voted for Alliant because for all around general reloading, I could get by with Bullseye, Unique and 2400 for a whole bunch of the metallic reloading I do, and Green Dot for most of the shotgunning. That said, for some specific applications (notably Schuetzen) I've long used IMR 4759 and some 4227 for my 32-40 and Hodgdon's H-108 for lead bullet bench rest. Note that 4759 and H-108 are both discontinued, but I've squirreled away a large enough supply of each to cover my shooting in those venues until I turn at least 80, so that's probably enough!
As others have indicated, this poll is to some degree influenced by what powder is available, by what kind of shooting the respondent does, and the old "Ford vs Chevy" phenomenon involving just which powder the respondent likes best without a real objective standard to base it upon. I will state I'm glad I have a backlog of powder work with and that over the years I've had the opportunity to evaluate a wide variety of powders.
Froggie
"It aint easy being green!"
The Best?
That's easy.
While Herters didn't make powder, the smokeless powder they sold was the World's Best, cleanest burning and always Guide approved...that with their Perfect Primers...you just knew you had the BEST.
~~~~~~~~~~~~~~
“If someone has a gun and is trying to kill you, it would be reasonable to shoot back with your own gun.”
― The Dalai Lama, Seattle Times, May 2001
The best one I've found is the one on the shelf when the others aren't available. Had to switch from Universal to 20/28 for 28 gage, and from H110 to Lil'gun for the .410. And I'm not going back!
The only amendment the Democrats support is the 5th.
I agree with most above, it's a personal choice and it depends...
I weigh most of my reload charges so while metering is important, not 100% essential to me. I'm not a "cleanliness nut" so if my load leaves some soot/debris, I'm OK with that. In 30+ years of reloading, I can't remember a "bad" powder and I've been able to work up good loads with almost every applicable powder. I have chosen some "classic" powders and made them preform quite well in my guns (Bullseye and W231 in my 38 Specials, Unique and 2400 in my 44s, IMR 4895 and IMR 4064 in my 30-06, etc.) but I will try "new and improved" powders too.
My Anchor is holding fast!
Alliant seems to maintain a consistent burning rate from lot to lot.
Old enough to know better, young enough to do it anyway!
Men who don't understand women fall into two categories: bachelors and husbands!
I would have to say ADI Powder is the "best" since they are the source for much of what I would buy under the label of the brands in the survey.
http://www.adi-powders.com.au/powder-equivalents/
Very useful list of equivalent powders from the different brands. We know that some powders are "really close" to a powder from a different brand. With ADI making the same powder for both brands one can see why they would be "close". The charts and load data on the ADI site can be most useful. Provides a good way to find what you need that is almost the same as what you wanted when you can't find what you wanted.
A shopping situation we have seen in the recent past and will probably see again, unless one has sufficient quantity on hand to weather the next panic or disaster induced shortage. ADI had a fire in the pistol powder production facility. That was one major reason for the shortage of pistol powders a few years back. Production Shortage + Sandy Hook = Panic Buying and stockpiling
Scrap.... because all the really pithy and emphatic four letter words were taken and we had to describe this source of casting material somehow so we added an "S" to what non casters and wives call what we collect.
Kind of hard to claim to love America while one is hating half the Americans that disagree with you. One nation indivisible requires work.
Feedback page http://castboolits.gunloads.com/show...light=RogerDat
RD, Thanks for the chart link. It does look useful.
--------------------------------------
OP, & All,
I did not vote, since while I use powders from more than one maker, I still try to use powders that are compatible with what I caliber I am using, as well as have options.
I primarily use Red Dot/Promo for many calibers as well as shotguns, due to it accomplishing what I want, it seems to be pretty accommodating thru a wide range of use in different calibers/gauges, & it is inexpensive as compared to other types of powders. ("Bang for the buck", literally)
While I have about 20+- different powders from Alliant, IMR, Hodgdons, etc., I don't choose what one is "best" for "All", but rather what is "best" for my use in whatever caliber /gauge I am using, & what I want the resulting cartridge/shell to do.
So far, since RD/Promo has been doing what I want, for most of what I want done, I would have voted Alliant, but that would not be fair, IMO, since I some of the other powders do a better job than Alliant in other calibers/gauges, so they would be the "best" in those types of uses. Picking one over the other would be difficult for me to do honestly, and so far all have been fine so I have no complaints one way or the other to say which one might be the "Worst" powder either.
Interesting topic for a, "What/Which is the Best.... ??" type topic, though.
2nd Amend./U.S. Const. - "A well regulated Militia, being necessary to the security of a free State, the right of the people to keep and bear Arms, shall not be infringed."
~~ WWG1WGA ~~
Restore the Republic!!!
For the Fudds > "Those who appease a tiger, do so in the hope that the tiger will eat them last." -Winston Churchill.
President Reagan tells it like it is: https://www.youtube.com/watch?v=c6MwPgPK7WQ
Phil Robertson explains the Wall: https://youtu.be/f9d1Wof7S4o
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |