Bought my first 9mm gun and it's Ruger PC Carbine, after making dummy rounds I noticed that there is no throat, the rifling pretty much right away and digs in to cast boolit, I have to seat it deep but not issues with plated bullets. Spent time reading forum and seems to be common problem and I need the throat reamed so my question is, even though I haven't slugged the barrel (I will) I measured the contact point and it appears to be around .356 I wanted to be able to shoot my cast bullets from .358 molds that I size to .358 without having to size it twice down to 356 or 357. So my question should I pick up this reamer which comes in .355 for 9mm or {.35 cal - .357 cal - .358 cal rifle} I do have lathe but haven't looked into how to remove hand guard / stock from the barrel and front sight in order to chuck it. I think I can machine a proper fit pilot for reamer to avoid buying a set of pilots. What's your recommendations?
P.S. I did want to send to Doug but the shipping and all is a bit cost prohibitive ($90-100)