I finally made the jump to serious bullet lubing. Ordered a Lyman 4500. My first mistake was ordering the wrong top punch, but that is irrelevant at the moment. I'm trying the lube/size some Lee 429-200-RF .44 mags. They keep getting jammed in the stupid lube die! Jammed as is in exerting so much force on the backstroke I am in fear of damaging the press. Finally had to hammer it out with a punch. Tried again with a .430 bullet already run through a Lee sizer. Same ****. Bullets are well lubed. Again, the top punch is incorrect for the bullet nose, but it isn't deforming the bullet enough to cause a stoppage. I'm currently at $400+ spent and very pissed off. Should have stuck with my $20 Lee sizers. Any ideas?