Budget Bullet Puller
1) wire stripper
2) Drill out hole in wire stripper or? 1 size smaller than the desired bullet; round off edges with file
3) Get proper shell holder
4) If cartridge won't reach through top of press, get pipe/tubing (PVC is OK) that will fit over the ram on your press and is ½ in taller than the (brass set in shell case in ram) your pulling the bullet out of. Raise the ram through the pipe/tubing- put case in shell holder. lower ram until boolit base is flush with the top of the pipe/tubing grip with stripper and lower ram to pull pistol boolits.