Picked up a S&W 64 from GB. It needed grips and a hammer nose. Picked up a set of Altamont grips and a couple of hammer noses from the internet. It's a DOC or LE trade in, however it appears to have been carried a lot and shot very little. Some cosmetic scratches that I plan to polish up a bit with flitz, however the bore and cylinder look very good. Loaded up a few 158 grs round nose flat point over 3.2 hrs of American Select with CCI primers. Shows some potential for accuracy. Grabbed a chunk of cardboard and stepped off 15 yards. Was able too keep all six shots on a 12x12 inch piece plywood at 50+ yards.
Attachment 194836