Here are the pictures of my problems.
I am casting using straight COWW and having no promblems with the fill out along the driving bands (the picture looks like I do but that's a problem with the picture. The problems I am having are "folds" in the bullets and "milky stains" on the bullets. The bullet with the fold is the best of the batch, there rest are a lot worse and not one cast gave me nice bullet. The other two bullets have the "milky stains" but I can't seem to get a good picture of it.
I am using a PID and have adjusted the temp from 600-800 in increments of 50 degrees to no effect other than getting frosty bullets with folds. I have heated the mold by dipping to the point where the lead in the mold takes over a minute to cool and get good results but that seems overkill. I have degreased the mold using Dawn, pure alcohol and carburator cleaner, all with the same results. I even cast with out lubing the mold just to make sure there was no lube getting into the cavity.
What am I doing wrong?
P.S. The mold is a Lee 311-100-2R. (.32 cal)