I got home from work, ate, and headed to the garage to cast some boolits. I really wanted to make a bunch of them tonght. It didn't work that way. I had one of the two cavaties that the boolit would stick in. After about a half hour of trying to just cast through it, I went and cleaned the mould. That worked but now one of the pins for the HP was sticking so I stopped again and tried to loosen the shaft. I broke one of the pins off. Ok, so now I put a new pin in so that it is just a FN boolit. My Lee 20 pot started leaking after awhile and I tried to clean it out. I used a wire to run up the spout. Leak stopped. After another half hour the spout started to plug up and I had a time of it gettting it to run again. Heat the mould up again so I can cast some. I cast for another hour and my back is just killing me. It is hot and as I lift my visor I'm wearing, the band that holds it on breaks. That's it. I go inside, take a shower and am glad I didn't burn myself. Just one of those kind of days. Vacation is in a week and I'm ready to go.