when I size and de-prime high base 20 ga cases I can't get them to eject from the sizer...the last 1/4" or so stays stuck in the resizer and I have to unscrew the sizing ring and then tap out the case. I have tried all the adjustments in the old manual without success.....any thoughts?
ps...the low base cases eject easily.
best
atr
Death to every foe and traitor and hurrah, my boys, for freedom !
I have the same problem, but haven't had time to try adjusting things yet.
reading the fine print in the manual they offer an upgrade to overcome this problem if the adjustments don't work. I think I might stick to Low base cases
Death to every foe and traitor and hurrah, my boys, for freedom !
tall steel hulls are a problem too much to size toss them in the trash
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote