Today I burnt my motor on my Bullet Master. The shear pin did not break when a hangup occurred. The fuse in my shop cut power but I was away for 5 minutes and when I got back the motor was really hot and it smelled like burnt electronics When starting it again the fuse broke again.
Do any of you guys have experience with these motors? Does anyone know how much these cost? Is my only option to buy a new one from Magma. I've been in contact with them and they may be able to help me out.
I'm attaching a bad Pic. It was the best I could do without taking the motor out. I'll take it out tomorrow and post better pics if needed. This was also requested by Magma to help me out. Their customer support seems very good. It took them 5 minutes to answer me today.
Lesson learned today is: Don't leave these machines running unnatended. Share pins may not break when they are supposed to!
Thanks
Sent fra min Pixel 8 via Tapatalk