Just a brief note to remind you that when you reload cast bullets that are larger than jacket, you may have to use an M-die expander to stretch the case enough in order to not bulge the case, while at the same time fitting the cylinder. Then once bullet is seated it will need to be crimped, I use a Lee FCD, just enough to hold but also enough to bring the case back down to size that will allow the cartridges to kerplunk into the cylinder and fall out freely. That’s what’s going on in this picture on the reloading bench today, making sure the finished cartridge is of correct size to fit the cylinder without stoppage. S&W 1905 3rd Change 4” barrel in 32WCF or 32/20.