I purchased several Lee precision case gauge's and a few 8-32 threaded cutters from titan reloading last week. I had only used the 1 for .223 so far. This evening I decided to load up some 450 bushmaster and I got the New 450 case gauge out and threaded it on to the cutter went to slide a piece of brass on it and it stops and will not go down around the gauge. I grab a different piece of brass and the same thing. I take it off my prep station. Take the calibers and measure it and it measures .447 so it's way over the inside measurement of my case's .443.5 to .444.5 All of my 450 Brass has been resized with a Brand New set of Lee dies from titan also.. I know this isn't titan's fault it's Lee's precision someone in QC has dropped the ball..
Any insight would be great..
God Bless
JDAS